3.1.
Removing the MCS II system from the helmet
Proceed as follows to remove the MCS II system from the helmet:
Remove the cheek padding and the shell gasket;
Completely remove the MCS II system from the helmet and re-install the cheek
padding and the gasket.
Fig. 8
Fig. 9
If
extension
positioned behind the
comfort cheek pad.
WARNING:
carefully check that the
extension cable does not
prevent the correct sliding
of
the
mechanism.
Unhook the right clip from the shell,
levering upward using a flat head
screw (or a similar tool), as shown
in figure 9.
not
used,
the
can
be
Please
VPS
inner
visor
13