Black Max BM3716 Manual Del Operador página 29

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SHARPENING THE CUTTERS
See Figures 46 - 49.
Be careful to file all cutters to the specified angles
and to the same length, as fast cutting can only
be obtained when all cutters are uniform.
WARNING:
The saw chain is very sharp. Always wear pro-
tective gloves when performing maintenance
to the chain to prevent serious personal injury.
 Tension the chain prior to sharpening. Refer to
Adjusting The Chain Tension.
 Use a 5/32 in. diameter round file and holder.
Do all of your filing at the midpoint of the bar.
 Keep the file level with the top plate of the tooth.
Do not let the file dip or rock.
 Using light but firm pressure. Stroke towards
the front corner of the tooth.
 Lift the file away from the steel on each return
stroke.
 Put a few firm strokes on every tooth. File all left
hand cutters in one direction. Then move to the
other side and file the right hand cutters in the
opposite direction.
 Remove filings from the file with a wire brush.
WARNING:
Improper chain sharpening increases the poten-
tial of kickback, which can result in serious
personal injury.
WARNING:
Failure to replace or repair a damaged chain
can cause serious injury.
NOTICE:
A dull or improperly sharpened chain can cause
excessive engine speed during cutting, which
may result in severe engine damage.
MAINTENANCE
RIVET HOLE
Page 29 — English
CUTTING
TOP PLATE
CORNER
HEEL
GULLET
LEFT HAND
CUTTERS
RIGHT HAND
CUTTERS
SIDE PLATE
DEPTH GAUGE
Fig. 46
TOE
Fig. 47
Fig. 48
Fig. 49

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Bm3716vnmBm3818Bm3818vnm

Tabla de contenido