Flux's ROMA Manual De Usuario página 17

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

to remove. To clean hold wet cloth very clase to tip of nozzle and open steam control �. Let
steam escape into the cloth for one or two seconds to clear out nozzle. Wipe outside of nozzle.
Clean by soaking in hot water, then replace. lf necessary, use a needle to clean air intake hales on
side of frother;
No Briel parts should be placed in the dishwater. This will cause distortion and may result in the
parts not functioning proverly or safely;
From time to time, remove lower section of frother by holding upper part and unscrewing lower
part. Clean carefully and reassemble;
Clean filter-holder and coffee filters with water after each use;
Remove drip tray and grid and wash with warm water. Use sponge to clean out drip area;
Ground coffee will adhere to the seal inside of the brew head. Keep it clean;
When the machine is not in use for a long period, drain stale water from machine by turning the
coffee function ON. However, do this only after you have filled reservoir with fresh water. Never
operate pump unless there is water in the machine;
Wash Cremaker filters and the filter-holder regularly;
The water tank and the drip tray can be removed for an easier cleaning;
The cappuccino nozzle can be removed from the steam tube for cleaning.
Descaling:
lt is advisable to descale the appliance every 4- 6 months, depending on the hardness of the water
and the frequency of use.
Fill the water tank with a 50% water, 50% vinegar solution;
Place a recipient under the brew head without filter-holder;
Turn ON the coffee funtion óand let most of the solution flow to a recipient;
Turn OFF the coffee function, put the recipient under the Cappuccino nozzle and open the steam
controlc&b;
When the water tank is nearly empty, clase the steam control;
To remove traces of the descaling solution, fill the water tank with fresh water and turn ON the
coffee function ó . Let flow the equivalent to 2 anda half water tanks, and turn the coffee function
OFF&;
Open the steam control�, , and turn the coffee function ON<!J>, and let the remaining water on the
water tank flow. Pay clase attention to the water level, as you must never operate the machine
without water in the tank!
L'.t
This operation may be hazardous if other substances are used instead of approved descaling
materials recommended for household coffee makers. Product failure due to scale accumulation
is not covered by the warrant}( No other servicing should be attempted by the user.
-
Environment protection first!
'tbur appliance contains valuable materials which can be recovered or recycled.
Leave it at a collection point.

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido