Charging Process; Disconnecting The Charger - auto XS EA-2138 Manual Del Usuario

Reactivation via pulse charging is the same for all 12 V charging
programs.
For this reason, you can still switch to the car
charging programs (depending on the connected battery or
the ambient temperatures) even if the battery voltage is still
below 10.5 V. Tap the mode button to do so.
If the battery voltage is still at 7.4 V or 7.5 V after 1.5 minutes, the battery is de-
fective. The charger will switch to standby mode
− Disconnect the charger (see chapter "Disconnecting the charger").

Charging process

If the correct charging program is selected and initiated, the display
will show
• the symbol for the respective charging program (
• the voltage indicator
• the indicator for the battery charge level
filled fields indicate existing capacity; blank fields indicate missing charge).
The frame around the battery symbol will blink during the charging process
(see Fig. E).
Once the battery is fully charged, all fields of the battery symbol are full and
the frame will be shown continuously in the indicator. The voltage indicator will
show CHA (see Fig. F).
The charger will switch to trickle charge to maintain the battery's charge level.

Disconnecting the charger

WARNING!
Danger of explosion!
Improperly disconnecting the charger may produce sparks. An
explosion may be triggered by highly explosive detonating gas
resulting from the charging process.
− Always disconnect the charger from the power grid first.
− Follow the correct order of steps when disconnecting the
battery terminal clamps (+/-) from the battery or chassis.
15 (displays the current voltage for the battery).
8 or cold
14 for reasons of safety.
7 , 8
11 (indicates the charge level;
Operation
9
1
, 9 or 10 ).
19