Marmitek MegaView 91 Modo De Empleo página 6

5. INSTALLATION IR RETURN
The MegaView 91™ has a built-in "infrared return channel", which allows
you to operate the connected device from another room or through closed
cabinet doors using your own remote control.
1. Connect the IR receiver to the MegaView 91™ receiver [6].
Position it so that it is visible to your (infrared) remote control, allowing

it to receive the transmitted commands (up to 6 metres).
The most logical place for the IR receiver is in the vicinity of your

display device (HDTV or projector).
By using the supplied adhesive strip, placement is possible virtually

anywhere.
Experiment to find the right position before definitive attachment of the

IR receiver.
Attention! The adhesive strip may cause discolouration on certain
surfaces, or may leave adhesive residue when removed.
2. Connect the IR extender cable to the MegaView 91™ transmitter [7].
Stick the IR blaster LED near the HDMI source.

When positioned correctly, one blaster LED can operate all A/V devices

within the same compartment of a cabinet.
Experiment to find the right position before definitive attachment of the

IR blaster LED.
Attention! The adhesive strip may cause discolouration on certain
surfaces, or may leave adhesive residue when removed.
6. USAGE
1. Switch on the HDMI source (e.g. TV Decoder or Media Centre PC).
2. Switch on the display device (for instance HDTV or projector) and
select the appropriate input. Usually you will do this by pressing the A/V
or EXT button of your remote control.
3. You will receive images from the connected A/V device immediately.
4. The MegaView 91™ can also be used to operate the HDMI source
from another room, by pointing your own remote control at the IR
receiver and pressing a button.
6 © MARMITEK