Frequently Asked Questions - Marmitek MegaView 91 Modo De Empleo

5. When everything is working normally, the 'DATA' LED on the receiver
will flash rapidly and the 'LINK' LED will light up continuously.

7. FREQUENTLY ASKED QUESTIONS

Bad (or no) image and sound
Please check that the HDMI source is on.

Use only CAT5e/CAT6 cable as specified in chapter 3 (CAT5e Cable

Requirements).
Check if the CAT5e/CAT6 cable provides a solid connection (no cable

faults).
Check if the RJ-45 has been connected according to the EIA/TIA

T568B standard.
Please ensure that the maximum cable length is not exceeded.

Install your system as far away from any RF sources (wireless devices)

as possible.
Set a low resolution on your HDMI source. The CAT5e/6 cable used

probably cannot deal with the higher resolution bandwidth.
The screen will display the text "Waiting for connection"
When both the ''LINK'' and ''DATA'' LEDs are not lit on the receiver,

check the cable connections to the transmitter and the sender.
When the transmitter and receiver are connected through a network

(with routers / switchers), and the "DATA" LED is slowly blinking on the
receiver, check the cable connection between the transmitter and the
network.
The screen will display the text ''Please check the TX input signal''
 Please check that the HDMI source is on.
Do you have any questions that are not answered above?
Please check www.marmitek.com.
MegaView 91™ 7