Ingersoll Rand Schlage CO-220-75 Guia Del Usuario

P516-751
SAFE SCHOOL BUTTON OPERATION:
The Safe School Button is located on the Safe School Printed Circuit Board Assembly (PCBA).
The Safe School Button is used to pair and add additional fobs to the lock.
The Safe School Button can also be used to remove all paired fobs from memory.
To access the Safe School Button, remove the INSIDE escutcheon cover.
LOCK AND FOB SETUP:
Note: Lock and fob are already paired when coming from the factory.
Pairing a Fob to the Lock:
1) Press and hold the Safe School button for 5 seconds until the blinking green LED is observed on the
inside of the lock. Release the Safe School button. The green LED will continue to blink.
2) Press and hold the button on the fob. The green LED will stop blinking and turn a solid green for
2 seconds when pairing is complete. Release the fob button.
Erasing all Fobs from the Lock:
1) Press and hold Safe School button for 20 seconds until blinking red LED is visible on the inside of the
lock. Release the Safe School button. The red LED will continue to blink.
2) Press and release the Safe School button. The red LED will stop blinking and turn a solid red for
2 seconds once the fobs have been erased.
Erasing Lock from the Fob:
1) With the fob out of range of any paired doors, open the fob housing with a screwdriver or coin
and remove the battery.
2) Place the battery back into the fob and close the fob housing.
3) Within 1 minute of reinstalling the battery, press and hold the fob button for 5 seconds.
CO-220-75 Function
Standalone Classroom Lockdown Solution
USER GUIDE AND PRODUCT SPECIFICATIONS
Safe School Button