Assembly Instructions - Kobalt SGY-AIR134TZ Manual Del Usario

ASSEMBLY INSTRUCTIONS

1. Remove plastic air inlet protective cap from
air inlet (E) as shown in Fig. 1.
2. Prepare a 1/4 in. male plug (not included) by
applying sealant tape to the threading, wrapping
clockwise. Screw threaded male air plug by
hand into air inlet as shown in Fig. 2 and tighten
with a wrench (not included) for an airtight
connection. DO NOT OVERTIGHTEN.
Sealant tape must be used on this
NOTE
connection.
3. Select the correct impact socket (not included)
for the threaded fastener to be tightened or
loosened and mount it onto the anvil (B) until it
clicks into place as shown in Fig. 3.
Use only adapters and sockets with a torque
rating equal to or greater than the tool itself.
Always make sure adapters and sockets are
properly mounted and secure before using the tool.
Loose attachments can break or fly off, causing
serious injury to the operator or bystanders in the
work area. Always follow all manufacturers'
specifications for proper attachment and use.
WA R N I N G
1
2
3
11