Progress Lighting AirPro P2596 Manual De Instalación página 12

Installing the Transmitter
Holder
Select a location to install your remote control
system transmitter. You can replace an existing
wall switch or, install the transmitter on ANY
flat surface.
Option 1: Install the remote control system
using an existing wall switch outlet box. Make
sure the electrical power is TURNED OFF at
the main panel before continuing.
Step 1. Remove the existing wall plate and the
old switch from the wall outlet box. Wire nut the
BLACK leads (hot) together and push back
inside the outlet box. (Fig. 17)
Step 2. Install the metal plate and holder to the
existing wall outlet box with 4 screws provided.
(Fig. 18)
Option 2: Install the control system on ANY flat
surface.
Select the desired location and use the holder to
mark the location for the mounting holes. Plastic
wall anchors and screws are provided for this
type of installation. After installing the wall
anchors, attached the holder with the mounting
screws. (Fig. 19)
9.
Outlet box
Switch
Figure 17
Outlet box
Metal plate
Holder
Screws
Figure 18
Wall plate
Figure 19
Screws
Plastic
anchor
Screws
Holder
Wall