TOOLS REQUIRED
Adjustable Wrench (Not Included)
Estimated Assembly time: 5 minutes (Not including mounting)
PARTS LIST
A
B
C
ASSEMBLY INSTRUCTIONS
1. Remove the top flange nut on the grip handle (C). Attach
the handle and lower nut to the steel crank. Using adjustable
wrench or your hand, tighten nuts on the front and back of
the steel crank. - The two nuts may be adjusted to allow the
handle to rotate freely. Figure 1
FIGURE 2
4. Attach your garden hose to the hose connection and wind
around the hose reel spool (E).
• DO NOT leave water running through the hose reel
unsupervised.
• DO NOT expose the reel to freezing temperatures with water
remaining in the unit.
• Turn the water off after each use.
IMPORTANT: LAY OUT ALL PARTS AND FASTENERS. MAKE SURE ALL PARTS ARE ACCOUNTED FOR. IF ANY
PART IS MISSING PLEASE CONTACT LIBERTY GARDEN PRODUCTS AT 1-866-820-5805. DO NOT CONTACT
THE RETAILER. YOU CAN ALSO VISIT OUR WEBSITE, WWW.LIBERTYGARDENPRODUCTS.COM, FOR MORE
INSTRUCTIONS PICTURES AND HELPFUL HINTS.
A. STAKES (4)
D
B. BUMPERS (4)
C. GRIP HANDLE (1)
2. Attach the leader hose (D) to the swivel connector. Figure 2
Note:
If you have trouble with the swivel turning and kinking the leader hose, try spraying a
silicone spray inside to lubricate the O-rings. The O-rings located inside the swivel may be dry.
You can reach the O-rings by taking off the retaining clip or spraying inside the opening of the
D
swivel.
Figure 3
E. HOSE REEL (1)
2
(Not pictured)
FIGURE 1
C
E
E
FIGURE 3