How To Use - Black and Decker Cyclone BLC12600B Libro De Uso Y Cuidado

Product may vary slightly from what is illustrated.


† . Lid cap (Part # 08FI)
† . Lid (Part # 08EE)
† . Perfect Pour™ blending jar 6 cups / 8 oz. / 0 ml (Part # 9900)
. Handle
† . Blade assembly (Part # 77766)
† 6. Gasket (Part # 096-)
† 7. Jar base (Part # 098EZB)
8. Speed buttons
9. display
0. PULSE/OFF button
. Base
Note: † indicates consumer replaceable/removable parts











How to Use

This unit is for household use only.
GETTING STARTEd
• Remove all packing material and any stickers from the product.
• Please go to www.prodprotect.com/applica to register your warranty.
• Wash all removable parts as instructed in CARe ANd CleANING section of
this manual.
BLENdER JAR ASSEMBLY
1. Turn blending jar upside down and place flat on countertop or work
surface.
2. Put the gasket on top of the blade assembly.
3. Place the blade assembly with gasket in bottom opening of the jar with
blades down.
4. Place jar base onto jar and rotate clockwise until
it is tight (A).
5. Turn assembled jar right side up.
6. Place lid with lid cap on blender jar.
7. Uncoil power cord from storage area under the
base.
A
8. Place jar assembly in unlocked position on base
and turn jar clockwise until jar is in the locked
position (B).
9. Blender is now ready for use.
B
USING YOUR BLENdER
Important
• If the appliance overheats, please unplug, wait 0 seconds and then plug
in again. If it happens again, repeat the same process.
• If appliance runs for more than  minutes, the motor will shut off. If this
occurs, press any speed button to resume operation.
• If the PULSE function stops working, simply unplug the power cord and
wait  seconds for the unit to reset. For HIGH / LOW function, press any
speed button to start blending again.
1. Make sure appliance is unplugged.
2. Place foods to be blended into jar, liquid first.
3. Place lid on jar; make sure lid cap is in place.
4. Place the jar on the base of the blender.
5. Plug power cord into outlet. The word oN appears on the lCd and remains
on until the blender is unplugged.