Aligning The Appliance - Thermador T18BF Serie Instrucciones De Instalación

10. Aligning the appliance

m
CAUTION
Never use a cordless screwdriver!
Risk of damage to the appliance.
NOTE
– Do not twist or jam the appliance inside the cavity!
When unscrewing the height-adjustable feet,
proceed gradually: Always alternate between left
and right, left and right, etc..
– The adjustment of the rear feet is facilitated if the
appliance is unloaded at the rear.
– If using a wooden beam as an alternative anti-tip
device according to point 6 of this installation
manual, rotate the appliance all the way towards the
wooden beam.
̈
Remove base panel from the appliance.
m
̈
Align the appliance with the furniture fronts.
The height-adjustable feet at the front and rear can all be
adjusted from the front.
Front:
Rear:
A mark is attached to the appliance base and is used as a
standard gage for height adjustment. When adjusting the
height, align this mark at a height of 1
floor.
̈
Unscrew the height-adjustable feet until the mark on
the base has reached the indicated guide dimension
1
(1 / " / 32 mm).
4
It is very important to comply with this dimension for
the subsequent alignment of the furniture fronts.
̈
Align the furniture fronts with the spirit level.
with open-ended wrench
5
with / " (8 mm) hex nut driver via flexible shaft.
16
NOTE
1
/ " (SW13)
2
1
/ " (32 mm) above the
4
23