System Operation - golmar Vista Nexa Guía Rápida

VIDEO SYSTEM PLUS NEXA - BUILDING
( ) SAFETY PRECAUTIONS
*
- Install or modify the equipment, without the power connected.
- The installation and handling of these equipments must be performed by authorised personnel.
- The entire installation must be at least 40 cm.
- With power supply, monitor, telephone and distributor:
w Do not use excessive force when tightening the connector screws.
w I nstall the equipments in a dry and protected place without risk of drip or water projections.
wAvoid to place it near to heating sources, in dusty locations or smoky enviroments.
wDo not block ventilation holes of the unit so that air can circulate freely.
wTo avoid damage, the power supply has to be firmly fixed.
wTo avoid an electrical shock, neither remove the protection cover nor handle the connected wire
in the terminals on the power supply .
( ) ( ) CHARACTERISTICS
* *
- Audio and video door entry system with simple installation specially-designed to replace 4 + n audio
door entry systems. Installation is done through 5 common wires without independent call lines .
- Bus Nexa CN7: It allows the connection of illumination module (Nexa code panel, see manual
TCode/CA Nexa).
- Up to 6 door (access) panels which do not need switching units.
- Up to 200 monitors / telephones per installation or backbone without using converters.
- Up to 132 apartments with door panels of push buttons and up to 200 apartments with Stadio/ Inox coded
panels (requires the use of the digital converter
- Acoustic busy channel and call acknowledgment signals.
- Visual indications on the door panel for people with impaired hearing: (call and communication
process, door release and busy system).
- Door opening timed at 3 seconds.
- A.C. or D.C. lock release operated through a relay.

SYSTEM OPERATION

To make a call the visitor should press the push button corresponding to the apartment he
O
wishes to contact. An acoustic tone will be heard confirming the call is in progress once the push
button has been pressed and the door panel led
received at the monitor (telephone) in the dwelling. During the call the visitor can correct his call
by pressing a push button corresponding to a different apartment, in which case the original call
is cancelled.
In systems with several accesses doors, the other(s) door panel(s) will be automatically
O
disconnected:
If a visitor tries to call from other door panel an acoustic tone will be heard and the door panel
led will be on confirming the system is busy
The call tone will be reproduced on the monitor during 3 seconds: after this time the picture will
O
appear on the master monitor without the visitor being aware of this. To see the picture in a
slave monitor p ick up its handset , dissapearing the picture on the other monitor. If the call is not
answered in 45 seconds, the door panel led
To establish communication pick up the monitor (telephone) handset
O
The communication will last for one and a half minutes or until the handset is replaced. Once the
O
communication has finished the door panel led will turn off and the
To open the door, press the door release push button during call or communication progresses:
O
with one press, the door release operates during 3 seconds. During the lock release activation
an acoustic tone will be heard on the door panel confirming the lock release is activated and the
led will also turn on for 3 seconds.
If there are SU-R5 Relay Units in the installation, two rapid presses open the door release of the
'second door' or the door release of the SU-R5 Relay Unit selected (see TSU-R5ML manual).
( ) DEFINITION AND MINIMUM REQUIREMENTS
*
- Before installing this system, we must ensure that the existing installation complies with the
minimum requirements described in the manual "T632/R5 ML".
( ) For more information see manual "T632/R5 ML (cod. 50121860)".
*
https://doc.golmar.es/search/manual/50121860
away from any other installation.
CD-PLUS/R5 ) or Nexa code panel with Cn7 Bus Nexa.
will turn on . At this moment the call will be
.
will turn off and the system will be freed.
, door panel led will turn on
system will be freed.
2
VIDEO SYSTEM PLUS NEXA - BUILDING
DOOR PANEL INSTALLATION
( )
*
1650
1450
The push buttons module EL610D must be configured, to assign a call code to the push
buttons (use the tool that is supplied with the sound module). Make this configuration
with the dip switch placed in the back side of the module.
Depending on the setting selected, the push buttons are assigned to a specific call code.
In case to combine these door panels with coded door panels or porter's exchange, it will
be necessary to known the call code of each push button, as shown in the table below.
Dip1 Dip2 Dip3 Dip4 Dip5 Dip6 Dip7 Dip8
1 On Off
2 Off On
3 Off Off
4 Off Off
5 Off Off
6 Off Off
7 Off Off
8 On Off
9 Off On
10 Off Off
11 Off Off
12 Off Off
13 Off Off
P1- P10: Push button 1 to push button 10.
(1)
Note:Sound module factory set the code "
Important: Select a different configuration option for each module EL610D.
.
Factory default.
( ) 2
( ) Description and adjustments:
*
- Description of the visual indications on the door panel.
- Description of the door panel led lights (only EL632/R5 module).
- Description of the SW1 con guration dip-switch and CN7 Bus Nexa connector.
- Adjustment audio volume.
( ) DESCRIPTION AND PROGRAMMING MONITORS / TELEPHONES
*
( ) INSTALLATION
*
- To make maximum use of the existing installation, pay careful attention to the indications
described in the manual "T632/R5 ML".
( ) For more information see manual "T632/R5 ML (cod. 50121860)".
*
https://doc.golmar.es/search/manual/50121860
Embedding box dimensions:
Door panel 90CS 90C
Model CE A90C CEV90C
1850
W 99 99
H 1 3 4 250
D 40 56
Push buttons module EL-610D
Dip switch
Push buttons code
P1 P2 P3 P4 P5 P6 P7
Off Off Off Off Off On 1 2 3 4 5 6
Off Off Off Off Off On 11 12 13 14 15 16
On Off Off Off Off On 21 22 23 24 25 26
Off On Off Off Off On 31 32 33 34 35 36
Off Off On Off Off On 41 42 43 44 45 46
Off Off Off On Off On 51 52 53 54 55 56
Off Off Off Off 61 62 63 64 65 66
On On
Off Off Off Off Off Off 71 72 73 74 75 76
Off Off Off Off Off Off 81 82 83 84 85 86
On Off Off Off Off Off 91 92 93 94 95 96
Off On Off Off Off Off 101 102 103 104 105 107
Off Off On Off Off Off
112 113 114 115 116 117
Off Off Off On Off Off 122 123 124 125 126 127
in P1 and "
, 106" 132"
3
90
CEV90
99 mm.
328 mm.
56 mm.
( ) 2
P8 P9 P10 (1)
7 8 9 10 ( ) 2
17 18 19 20
27 28 29 30
37 38 39 40
47 48 49 50
57 58 59 60
67 68 69 70
77 78 79 80
87 88 89 90
97 98 99 100
108 109 110 111
118 119 120 121
128 129 130 131
in P2 .