WRAPPING THE CUFF
1
With the tube of the cuff positioned in
the direction of the fingertips, place it
on your left arm.
2
Wrap the cuff around the arm with the
edge of the cuff approximately 2~3 cm
above the elbow.
3
Press the surface of the cuff to make
sure that it is attached securely.
MEASUREMENT PROCEDURES
Take deep breaths and relax.
Do not move, chat or strain your arm or hand during measurement.
1
Insert TUBE PLUG
2
Set AIR CONTROL VALVE
SIDE
.
11
Press ON/OFF BUTTON
3
"
" flashes after the initial display and the inflation mark "
4
Set AIR CONTROL VALVE
RELEASE SIDE
5
Rapidly squeeze INFLATION BULB
cuff to 30-40 mmHg above your systolic pressure.
6
Gently place INFLATION BULB
The displayed value (pressure) decreases.
The pulse is indicated by heart mark "
The deflation mark "
Set AIR CONTROL VALVE
7
SIDE
11
and release air from the cuff.
Maximum and minimum blood pressures and
pulse rate are displayed.
into AIR CONNECTOR
13
to RAPID EXHAUST
9
.
2
to CONSTANT AIR
9
.
10
8
".
" flashes as the measurement completes.
to RAPID EXHAUST
9
When wrapping the cuff, wrap it loosely enough
around the arm so that two fingers can be placed
between the cuff and the arm. If the cuff is wrapped
more tightly or loosely than this, inaccurate blood
pressure readings may result.
If you are wearing a shirt that might restrict
circulation in your upper arm or you roll your
sleeve up over the upper arm, the blood flow will
be restricted, preventing accurate measurement.
.
4
" starts to flash.
to inflate the
8
on the table.
- 10 -
see fig.3
see fig.4
Stopping Measurement
Set AIR CONTROL VALVE
RAPID EXHAUST SIDE
press ON/OFF BUTTON
OVER-
PRESSURIZATION
Set AIR CONTROL VALVE
RAPID EXHAUST SIDE
release air from the cuff.
If the inflation mark flashes again
during the measurement,
start squeezing INFLATION
BULB
to inflate again to a
8
level about 30 mmHg higher in
4 sec., or the "Err" appears on
the display.
page 4
page 5
9
to
and
11
.
2
See page 14.
to
9
and
11
See page 14.