Instructions For Charging The Battery; Temperature Of The Battery And Specifications - Nilox DOC OFF ROAD Manual De Instrucciones

•
Only use the battery charger provided by our company.
•
If they are over-charged, lithium batteries can explode.
•
Do not throw into a fire.
I
NSTRUCTIONS FOR CHARGING THE BATTERY
•
Find the battery
compartment on the back
of DOC.
•
Make sure it is fully dry.
•
Connect the battery
charger to the electrical
mains (100V-240V;
50,60Hz), make sure it is
switched on and then
connect the other end
of the charger to DOC.
•
The red control light on the
battery-charge means
that it is charging correctly.
•
When the control light goes from red to green, the battery is fully charged, so
unplug the battery-charger.
•
Charging time is about 90-120 minutes.
•
Keep the charging contacts clean and dry.
•
If the battery compartment is not dry, do not charge DOC.
PLEASE NOTE: IF THE BATTERY IS KEPT CHARGING FOR EXCESSIVELY LONG PERIODS
ITS LIFE CYCLE WILL BE REDUCED.
T
EMPERATURE OF THE BATTERY AND SPECIFICATIONS
For DOC to operate efficiently, the temperature of the battery must be within the range
shown below and the temperature, before and after charging, must be within the
recommended range.
The efficiency of the charging process will be maximized if the following conditions are
respected.
A temperature that is excessively high or low increases charging time and reduces
efficiency.
Battery
Charging time
Volts
Amps
Use temperature
Charging temperature
EN
Lithium Ion
about 90-120 minutes
36
4.3 Ah
-20°C / 60°C
0°C / 45°C
13