Filter Replacement - Guardian AC5350 Serie Instrucciones De Uso Y Cuidados

OPERATING INSTRUCTIONS
BEFORE OPERATING THE AIR PURIFIER:
1. Select a firm, level and flat location for the air purifier.
* For proper air flow, locate the unit at least 1 foot from any wall or furniture.
* Make sure none of the grills are blocked.
2. Plug the power cord into a 120V AC outlet.
IMPORTANT: When moving the air purifier, always lift unit by the carrying handle located on back.
OPERATING THE AIR PURIFIER (AC5300 SERIES):
1. Turn unit power ON. To turn OFF, press and hold button for 3 seconds.
2. Select fan speed MODE 1 - 3
1 = low, ultra quiet sleep mode
3 = high
3. Select UV-C ON or OFF using UV-C Mode Button.
Filter Replacement Indicator: The Replace HEPA light on the control panel
will illuminate and flicker indicating that it is time to replace your filter. Replace the filter
according to directions (E-7) then press and hold the UV Mode button for 3 seconds
to reset the system.
UV Bulb Replacement Indicator: The circular blue light on the front panel of the purifier will flicker
when it's time to replace the bulb. Replace the bulb according to directions (E-8), then press
and hold UV Mode button for 3 seconds to reset the system.
OPERATING THE AIR PURIFIER (AC5350 SERIES):
1. Turn unit power ON.
2. Select fan speed MODE 1 - 5
1 = low, ultra quiet sleep mode
5 = high speed allergen control - Default setting is 5
3. Select UV-C ON or OFF using UV-C Mode Button.
4. TIMER: If you prefer to run the purifier for a specific number of hours, you can
select between 1 and 8 hours on the display.
Filter Replacement Indicator: The Replace HEPA light on the control panel will illuminate and
flicker indicating that it is time to replace your filter. Replace the filter according to directions (E-7)
then press and hold the Timer Set button for 3 seconds to reset the system.
UV Bulb Replacement Indicator: The circular blue light on the front panel of the purifier will flicker
when it's time to replace the bulb. Replace the bulb according to directions (E-8), then press
and hold UV Mode button for 3 seconds to reset the system.
Control Panel Beep/Sound: The sound emitted from pressing the buttons on the control panel
can be turned off/on by holding the Speed button for 3 seconds.
E-6

FILTER REPLACEMENT

The Air Cleaner will beep for 30 seconds and the Replace HEPA light will flash
continuously indicating that it is time to replace your filter. Replace the filter according
to directions then restart the system. Depending on usage, filter will last approximately
6 months.
1. Turn off and unplug the unit.
2. Press the lock and
3. Remove the used
release button and
Combination Filter
remove the rear
(Filter C) and dispose of
cover from the unit.
it in the garbage.
5. Reattach the rear cover of the unit and securely latch into place.
CHECKING AND MAINTAINING FILTER
Maintain the filter by checking it frequently.
Depending on air quality conditions, you may need to replace it more frequently.
Vacuum the carbon filter layer as needed to remove loose debris and dust and to help prolong
the life of your filter.
To check the status of the filter, peel back the carbon layer to expose the pleated filter.
If the filter is no longer white and is covered in grey dust/dirt it should be replaced.
IMPORTANT: Do NOT try to wash and re-use the Combination Filter.
IMPORTANT: To maintain the performance of the air cleaner, use Guardian Technologies
GENUINE Replacement Parts only.
4. Insert filter system into the unit.
Consult the arrow on the filter
for correct installation direction.
E-7