Installing The Software - Cherry ST-1000 U Manual Del Usario

4 Installing the software

Note: Using the current driver
When installing, you should always
use the most current driver. The
current driver can be found on the
Internet at the following addresses:
• http://support.cherry.de
• www.omnikey.de.
4.1 Windows NT 4.0
Note: USB under Windows NT 4.0
As standard, Windows NT 4.0 does
not support USB technology.
However, a special USB driver
which allows you use the USB port
with the product is installed with the
Smartcard Reader software.
Precondition:
• Windows NT 4.0 Service Pack 3
or higher must be installed to your
PC.
• If USB support can be activated in
the BIOS, it must be activated in
BIOS Setup.
Note
The software for installation under
Windows NT is not included on the
Cherry CD. You must download the
software from the Cherry GmbH
web page.
8
How to install the software under
Windows NT 4.0
1 Bring up the http://
support.cherry.de web page.
2 Log in or register yourself.
The Cherry Internet Support
System – CISS page is opened.
3 Click the Software download
entry.
The page Software download is
opened.
4 From the list Product
designation select the entry ST-
1000 U.
5 From the list Language, select
the language in which you wish to
use the software.
6 From the list Operating system,
select the entry MS Windows NT
4.0.
7 Download the software.
8 Unpack the software.
9 Double-click the Setup.exe file.
10Select the entry CardMan 2020.
11Follow the installation instructions
on the screen.
12Restart the PC when the
installation is complete.