Cequent 24954 Instrucciones De Instalación página 6

9. Trim fascia: using the center of the fascia marked in step 1. 2.50 x 4.00 off center mark. Use drill to create radius. See Figure below.
Fascia trimming
2.50 X 4.00 cutout in fascia
required. Use drill to
create radius.
10. Reinstall fascia: starting from the center of the vehicle lineup and
gently reinstall the rear fascia and all fasteners in reverse order steps 2-4.
(Note: reattach any wiring hardness if removed)
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico Sheet 6 of 18 24954NP 11-10-16 Rev. A