TROUBLESHOOTING
22
Problem
Water is draining
- The drainage adapter was not
out of the hole at
removed when the pump hose was
the side of the
connected.
appliance when the
pump hose is
connected.
There is water left
- The pump does not run
in the water bucket
continuously. The pump is
even though the
activated only when the water
pump is enabled.
bucket is full.
- The pump does not completely
empty the water bucket.
The pump starts
- The pump is enabled.
running after 3
minutes when the
water bucket is
removed.
Call for service immediately in the following situations.
1
Power cord is too hot or damaged.
2
The product continues to operate when the water bucket is full, overflowing the bucket.
Possible Cause
Solutions
- The drainage adapter is only for
use with a garden hose for
continuous draining. If using the
pump, remove the drainage
adapter to allow the water to drain
into the water bucket rather than
out the drainage adapter.
- This is normal. The pump will
activate once the water bucket is
full. Once the pump stops, there
may be water left in the water
bucket. To avoid odor, clean the
water bucket at least once a week.
- Disable the pump by pressing the
Pump button before removing the
water bucket for cleaning.