Setting The Temperature Limiter - OWIM Miomare HG03549 Instrucciones De Montaje, De Uso Y De Seguridad

The spout can be swiveled to your desired
position. Make sure the spout is always posi­
tioned within the area of the sink, otherwise
escape of water can lead to serious flooding
to your house or building.
CAUTION! DANGER OF SCALDING!
When making the hot water setting please
ensure that the temperature of the water is not
too high.
Before installation, make yourself familiar with
all the existing services, e.g. water connection
and stopcocks.
Please read carefully through these operating
instructions before installing and using the
product. Keep all the safety advice and instruc­
tions in a safe place for future reference!
Installation
Installing the tap
Turn off the main water supply to prevent serious
leakage of water. Allow any remaining water
in the pipework to drain.
Install the tap as shown in Figs. A–D.
CAUTION! Do not bend the hoses or place
them under tension. Otherwise material dam­
age could result.
Flushing the tap
The tap must be flushed through before first use
to remove any dirt. To do this, follow these
steps (see Fig. F):
Screw the mixer nozzle
Open the main water supply and allow the
water to run for two minutes.
Then screw the mixer nozzle
10 GB/IE
off.
7
on again.
7
Operation
Bringing into use
Note: If the tap has not been used for a long pe­
riod flush the pipes through thoroughly in order to
avoid stagnation and build­up of residues in the
drinking water supply.
Open the main water supply.
Lift the control lever
or left in order to regulate the speed or temper­
ature of the water flow.

Setting the temperature limiter

The cartridge in this unit has a temperature
13
limiter. This function is not activated in the factory
(neutral setting).
CAUTION! Change the temperature limiter
setting only after the tap has been installed.
Follow Fig E. to set the temperature limitation.
Turn off the main water supply.
Remove the red / blue hot / cold label
fully by a small flat screwdriver.
Release the locking screw
clockwise using the Hexagonal key
CAUTION! Do not take the screw completely
out; just loosen it until the control lever
be easily taken off.
Take off the control lever
Loosen the cartridge end ring
Then, screw off the cartridge locking ring
by using a pipe wrench.
Now pull the setting ring
help of a screwdriver.
Note: Do not remove the cartridge
Place the setting ring
(see Fig. G).
Note: The setting ring
angle of the handle, so that the amount of hot
water can be limited.
Tighten the cartridge locking ring
tap body again by using a pipe wrench.
14
Then, tighten the cartridge end ring
and swing it to the right
8
care­
10
by turning it anti­
9
.
16
can
8
.
8
by hand.
11
12
upwards with the
15
.
13
in the desired position
15
can limit the turning
15
onto the
12
by hand.
11