Optional Accessories - Shure UA220 Guia Del Usuario

INSTALLING THE UA220 AS AN ANTENNA COMBINER
Refer to Figure 2 and install the UA220 Splitter/Combiner as an antenna combiner as
follows:
1. Mount four half wave antennas around the installation as desired.
2. Connect one of the supplied BNC male–to–male adapters to each antenna input
connector.
3. Connect one UA220 Splitter/Combiner to each of the the BNC male–to–male
adapters attached to the antenna input connectors.
4. Connect two antennas to each UA220 Splitter/Combiner. Use 50 ohm, low loss
antenna cable (RG–8x or equivalent).
Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ
Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ
Ñ Ñ Ñ Ñ
UA220 SPLITTER/COMBINER INSTALLED AS ANTENNA COMBINER
SPECIFICATIONS
RF Carrier Frequency Range
10 to 1,000 MHz
Voltage Wave Standing Ratio (VSWR)
1.2
Impedance
50 Ω
Isolation
20 dB
Insertion Loss
2 dB
Overall Dimensions
63.5 mm x 48.2 mm x 22.3 mm (2.5 in. x 1.9 in. x 0.9 in.)
Weight
45.3 g (1.6 oz)
FURNISHED PARTS
0.5 m (2 ft.) Coaxial Antenna Cable (4)
BNC Bulkhead Adapters, lockwasher, nut (2) 95A8647
BNC Male–to–Male Adapter (2)

OPTIONAL ACCESSORIES

1/2 Wave Antenna
7.6 m (25 ft.) Coaxial Antenna Cable .
15.2 m (50 ft.) Coaxial Antenna Cable
ANTENNA
INPUT A
FIGURE 2
. . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . .
ANTENNA
INPUT B
Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ
Ñ Ñ Ñ
. . . . . .
UA802
.
95A8738
UA820A
. . . . . . .
UA825
. . . . . . .
UA850
3
Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ
Ñ
Ñ