Locating Metal - WHITES ELECTRONICS TM 808 Manual Instructivo

The volume will increase and the meter will read higher when the
instrument is passed over a buried metal object. When the target is close to the
surface, the meter may go full scale and the volume of the beep will increase to
maximum. Remember, when searching in the AUTO position, the detector must
be kept in motion when trying to find the center of the target. If the detector is
stopped over the target, the sound of the signal will fade. Cross the suspected
target area from at least two directions noting the area of loudest sound and me-
ter indication. This procedure of "X-ing" over the target pinpoints target center.
When using the NO-AUTO position, a surface target can appear to be
VERY large. This is normal. The target must be "narrowed down" to determine
its location more accurately. Pass over the target area from at least two differ-
ent directions. When the meter goes "full scale", momentarily press and release
the PUSH BUTTON control. Continue to cross the target pressing and releasing
the PUSH BUTTON control several times. There will be a point where the meter
reading and speaker beep will "peak" out and start to drop back down. It is at
this peak that the front loop is over the buried metal object. Pressing and releas-
ing the push-button while the target is under the loop, will "shrink" the signal and
make pinpointing easier. When using NO-AUTO, the PUSH BUTTON is needed
to pinpoint the target whereas in the AUTO position, the AUTOMATIC THRESH-
OLD function pinpoints automatically.
The most efficient way to search an area is to use a grid-like pattern
over the area selected. Try to keep the grid lines no more than five feet apart.
Make several passes in one direction, then turn 90 degrees and make several
more passes to assure that you have not missed any buried object. The target
will usually be pinpointed under the front loop or antenna.
Sometimes deeper targets will appear to locate closer toward the rear
of the instrument. Usually this will be no more than 3 or 4 inches from the rear of
the front loop even for the deepest targets.

Locating Metal

(15)