Cord Management - PEERLESS Paramount PP730 Instalación Y Montaje

Cord Management
Attach cable tie anchor (H) to top or bottom of wall arm (AA) using M4 screw (M) as shown in figure 3.1. Secure
3
cables to wall arm (AA) using cable tie (G) as shown in figure 3.2.
AA
NOTE: Adjustment points (socket screws) are factory torqued for optimal performance. This factory torque setting is
recommended to prevent the screen from slipping over time. If more or less tension is desired follow this optional step.
You may not achieve optimal torque value if factory torque settings are adjusted.
If more or less tension is desired in tilt mechanism, remove snap caps as shown in detail 2. Insert a flat head
screw driver into slot and pry cap away from tilt mechanism:
• To adjust tilt, simply tighten or loosen socket screw no more than half a turn using 5 mm allen wrench (E).
• To adjust roll, simply tighten or loosen 10-32 nylock nut.
• Do not loosen socket screws or nylock nuts to the point they become disengaged from the mount. Doing so may
cause the screen to fall.
If more or less tension is desired in the arm pivot points,
do the following:
• To increase tension, turn socket screw clockwise with
3/16" allen wrench (I).
• To reduce tension, turn socket screw counter-clockwise with
allen wrench (I).
NOTE: Do not turn more than half a turn.
M
H
fig. 3.1
OPTIONAL
WARNING
SOCKeT
SCREW
SLOT
6 of 20
All other brand and product names are trademarks or registered trademarks of their respective owners.
G
SCreeN
fig. 3.2
CABLES
DETAIL 2
SOCKeT SCreWS
ISSUED: 10-01-07 SHEET #: 095-9272-2 06-15-09
© 2009, Peerless Industries, Inc. All rights reserved.
10-32 NyLOCK NUT
SNAP CAP
Peerless Industries, Inc.
3215 W. North Ave.
Melrose Park, IL 60160
www.peerlessmounts.com