Product Maintenance - Fellowes POWERSHRED P-35C Guia De Inicio Rapido

BASIC SHREDDING OPERATION
PAPER/CARD
1
Continuous operation:
Up to 2 minutes maximum
NOTE: Shredder runs briefly after
each pass to clear entry.
Set to Auto-On (I)
Continuous operation beyond
2 minutes will trigger
30-minute cool down period.
Safety Lock prevents accidental operation. To set, wait for shredding to stop, set control switch to Off (O) position, then slide black button down.
For greater safety, always unplug shredder after use.

PRODUCT MAINTENANCE

OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and could
ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty
your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
Set to Off (O), lift head and empty bin. Replace head on bin and follow any or all of the below procedures.
PAPER JAM
1 2
Set to Reverse (R)
Set to Off (O)
for 2-3 seconds
and unplug
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 1 year from the date of
purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free
from defects in material and workmanship for 3 years from the date of purchase by the original
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
remedy will be repair or replacement, at Fellowes' option and expense, of the defective part. This
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or
unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs
2
3
When finished shredding
Feed paper/card
straight into paper set to OFF (O)
entry and release
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
P-35C
Set to Off (O)
*Apply oil across entry
3
4
Gently pull uncut
Set to Auto-On (I) and
paper from paper resume shredding
entry. Plug in.
P-35C
P-35C
3
Set to Reverse (R)
for 2-3 seconds
15
Shredder doesn't start:
Make sure switch is in auto position (I).
Make sure safety lock is in unlock position.
Make sure head is on basket correctly.
Empty basket.
Wait 30 minutes for motor to cool down.
incurred by Fellowes to provide parts or services outside of the country where the shredder is initially
sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE
WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential
or incidental damages attributable to this product. This warranty gives you specific legal rights.
The duration, terms, and conditions of this warranty are valid worldwide, except where different
limitations, restrictions, or conditions may be required by local law. For more details or to obtain
service under this warranty, please contact us or your dealer.
To unlock, slide black button up.
3