Operation; Care And Cleaning; Troubleshooting - Home Depot GLACIER BAY 461-3001 Guía De Uso Y Mantenimiento

Operation

1
Flushing and checking for leaks
□
Ensure the faucet handles are in the off position,
and turn on the water supply to check for leaks.
If you discover any leaks, check your connections
to ensure they are installed properly.
□
Turn on the hot and cold handles to allow the
water to run for at least one minute. This
ushes away any debris that could cause
damage to internal parts.
□
Turn off the water.

Care and Cleaning

□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.

Troubleshooting

NOTE: Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
Problem
There are leaks from the
handle.
The water will not shut off
completely.
There is a leak from the
spout base when the
faucet is on.
Possible Cause
The bonnet nut has come loose and/or the
washer is dirty or damaged.
The cartridge is dirty or broken.
The o-ring which is on the connector
under the spout is worn.
□
□
□
□
□
7
Please contact 1-855-HD-GLACIER for further assistance.
Solution
Tighten the bonnet nut.
Clean or replace the washer.
Remove the handle to check
the cartridge.
Clean or replace.
Remove the spout and replace
a new o-ring.
HOMEDEPOT.COM