Maintenance - Thermador VCI2 Manual Del Usario

Cleaning Chart

Maintenance

Lights
Light Bulb Replacement
Table 1: Cleaning Chart
Part or Surface
Plastic (Buttons)
Stainless Steel
Glass
CAUTION: Turn power off at breaker before removing a damaged bulb.
Do not touch the bulbs immediately after use. The bulbs will remain hot
for several minutes.
• WARNING: Make sure the appliance and lights are cool and power to the
appliance has been turned off before replacing the light bulb(s). Failure to do
so could result in electrical shock or burns.
• The lenses (if equipped) must be in place when using the appliance.
• The lenses (if equipped) serve to protect the light bulb from breaking.
• The lenses (if equipped) are made of glass. Handle carefully to avoid
breaking. Broken glass could cause an injury.
Use a 12V halogen bulb (max. 20Watt) with a two pin, G4 base.
Note: DO NOT touch a new halogen bulb with your fingertips. Grasp the bulb
through a clean paper towel or facial tissue. The oils from your skin can reduce
the longevity of the bulb.
Suggested Technique
Wipe with sudsy water or
household cleaners such
as Fantastic or Formula
409, rinse well and dry
with a clean soft cloth to
avoid water marks.
Wipe and dry stainless
steel in the same direc-
tion as the grain. Avoid
using too much pres-
sure, which may mar the
surface. To remove fin-
ger prints and give
added shine, use clean-
ers such as Stainless
Steel Magic  .
Use warm soapy water
and/or a mild window
cleaner.
Cleaning and Maintenance
Notes
Do not allow any cleaning
compounds to remain in
contact with stainless steel
for extended periods.
English 5