Complete The Installation - Health Zenith DualBrite Manual Del Usuario

❒ Stuff the wires into the junction box.
Make sure the wires from the fixture go
through the wire path, and no wires get
pinched.
Slide the fixture onto the mounting
screws and tighten nuts.
❒ Caulk fixture mounting surface with
silicone weather sealant. You may want
to wait until you have completed the tests
and adjustments on pages 4 and 5.
❒ Install one 100 Watt max. light bulb (60
Watt max. light bulb for 4131 model), or
three 60 Watt max. light bulbs in cande-
labra style.
❒ If so equipped, install the fixture top.
Secure with decorative screws.
❒ If you will not be installing the
optional tail assembly, install the
decorative nut onto the bottom of
the fixture now.
4182 Top Assembly

COMPLETE THE INSTALLATION

Junction
Box
Larger piece
on top
Optional Assembly
❒ If so equipped, you may install the deco-
rative tail as shown below.
1. Screw in
extension
bar.
Bottom trim piece
has drain hole
TESTING
❒ Turn on the circuit breaker and light
switch.
NOTE: Sensor has a 1
period before it will detect motion.
When first turned on or when
switching modes wait 1
❒ Switch the on-time to TEST position and
Dual Br it e switch to the off position.
®
TEST 1 5 10 MIN
ON-TIME
Avoid aiming the control at:
• Objects that change temperature rapidly,
such as heating vents and air condition-
ers. These heat sources could cause false
triggering.
• Areas where pets or traffic may trigger
the control.
• Nearby large, light-colored objects re-
flecting light may trigger the shut-off feature.
Do not point other lights at the sensor.
4
Hex nut
2. Add tail
piece and trim.
3. Install
decorative nut.
/ minute warm up
1
2
/ minutes.
1
2
OFF 3 6 DUSK TO
HOUR
DAWN
595-5578-08