Introduction; Using The Circular Attachment To Sew Patterns In A Circle; About The Circular Attachment; Included Accessories - Baby Lock Symphony BLSY Manual Del Usario

INTRODUCTION

This Addendum provides additional information not described in the Instruction and Reference Guide.
Refer to these instructions after first reading the Instruction and Reference Guide provided with your sewing
machine.
USING THE CIRCULAR ATTACHMENT TO SEW
PATTERNS IN A CIRCLE

About the Circular Attachment

This device can sew circular patterns that graduate out at 5mm intervals, ranging from 30mm to 130mm in
radius* when the center needle position is selected. The device is set to the left of the needle on your sewing
machine. Utility and decorative stitches can both be sewn using this device.
*
Radius= Distance from center of circle to any point on the circle.
Note
• You cannot use any decorative stitch with side feeding or stitches with a width over 7.0 mm. Before sewing on your
project, be sure to sew trial stitches and check the sewing results. If stitches that cannot be used are sewn, the pattern
may become misaligned. For a list of stitches that cannot be used, refer to the table "LIST OF STITCHES THAT CANNOT
BE USED WITH THE CIRCULAR ATTACHMENT" located on page 17.
• Special care is required for the pivot pin; neglectful treatment may cause injury. Young children should be
supervised to ensure that they do not play with the attachment. When attachment is not in use, always
keep the pivot pin in the indicator to avoid its loss.

Included Accessories

1
2
No. Part Name
1 Circular Attachment
a Indicator
b Handle/Flips Up
c Release button
d Setting position for pivot pin
e Scale
2 Pivot Pin
3 Attachment Screw
(2pcs. one is extra)
2
4
3
Part Code
-
XE6016-001
XE6022-001
CAUTION
Conversion Chart
mm (f)
No. Part Name
4 Template
f Radius of circle in mm
g Angular lines listed in degrees
starting at 0 with 5 degree
intervals
h Center
5 Braiding Foot
6 Cording Foot
5
inch
130 5 3/16
120 4 3/4
110 4 3/8
100 4
90 3 1/2 6
80 3 3/16
70 2 3/4
60 2 3/8
50 2
40 3/2
30 13/16
Part Code
XE6024-001
XE5680-001
XA6871-001