Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
MACHINE COMPONENTS
2
1
5
3
6
1. 3- Speed Switch
2. Carrying Handle
3. Power Cord Storage
4. Air Outlet Vent
MACHINE OPERATION
1. Select suitable location for machine.
Ensure machine is in a safe operating location. Do
not place machine in a puddle and make sure it is
protected from drips and splashes.
2. Plug the power cord into grounded electrical outlet.
Always unwind power cord completely before
operating machine. Inspect power cord for damage
before each use. Replace cord immediately if
damaged.
3. Place the machine in the desired operating
position.
A. Horizontal - dry floors and carpets.
B. Tilted - dry floor finishes, paint, etc.
C. Vertical - dry wall and ceiling.
A
B
4. Set the desired speed by turning switch.
5. Check for proper operation before leaving the
machine unattended. Do not move or carry the
machine when it is operating.
6. To shut-off machine, turn the switch to the off (O)
position.
7. The machine is equipped with an automatic reset
motor overload shut-off thermal sensor to protect
motor from overheating. Should the shut-off
thermal sensor trip, it will reset automatically when
the motor has cooled sufficiently, usually after 15 -
30 minutes.
Tennant/Nobles 3-Speed Blower (10- 2016)
4
5. Air Intake Vent
6. Kick Stand
7. Wheel Cart (optional)
C
MACHINE MAINTENANCE
To keep machine in good working condition, simply
perform the following maintenance procedures.
WARNING: Unplug cord from outlet when not
in use and before servicing machine.
1. Inspect power cord for damage after each use.
Replace power cord immediately if damaged.
2. Clean machine with a damp cloth.
3. Check for dust accumulation around the air inlet
and outlet vents and clean if necessary. Blocked
7
vents will cause the motor to overheat, and may
lead to premature failure. Warranty claims for this
type of damage will not be accepted.
STORING AND TRANSPORTING
MACHINE
Neatly wrap power cord and store
machine in a cool dry area. Do not
expose to rain, store indoors.
Stack machines for storage as
shown.
CAUTION: Do not stack beyond
four high. Do not stack during
transporting and secure with strap.
SERVICING MACHINE
To maintain operational safety and reliability have the
machine checked annually or every 250 hours of use
by an Authorized Service Center.
TROUBLE SHOOTING
WARNING: Unplug cord from outlet when not
in use and before servicing machine.
If machine fails to operate:
- Check power cord for damage.
- Check plug connection.
- Check building circuit breaker.
- Thermal sensor shut-off - wait 15-30 minutes to cool.
- Contact service center.
MACHINE SPECIFICATIONS
MODEL
Width x Height x Depth
Weight
Voltage / Frequency
Motor Rating
Maximum Air Flow
Speeds - Low/Med/High
Power Cord Length
Sound Pressure Level L
Protection Grade
English EN
3- Speed Blower
15 in x 18.5 in x 18 in
38.1 cm x 47 cm x 45.7 cm
22.5 lb / 10.2 kg
120 V / 60 Hz
.6 HP, 522 W, 4.35 A
3
1350 cfm / 38.2 m
/min
710 rpm/1105 rpm/1550 rpm
18.5 ft / 5.6 m
69 dBA
pA
IP20
5
Publicidad
Tabla de contenido
