Tool Parts - Porter & Cable FR350A Manual De Instrucciones

Fig. 1
A. Exhaust deflector
B. Selectable trigger
C. Air Inlet with quick
connect coupler
D. Magazine
E. Nail follower
F. Safety contact trip
with No-mar pad
G. Depth adjustment
wheel
H. Pusher release
I. Pusher
G
f
Disconnect air line from tool and remove fasteners from magazine
before making adjustments or personal injury may result.
trIGGer
Keep fingers AWAY from trigger when not driving fasteners to avoid
accidental firing. Never carry tool with finger on trigger. In bump action mode (contact
actuation mode) tool will fire a fastener if safety is bumped while trigger is depressed.
The FR350A is equipped with a selectable trigger. This trigger allows the operator to select
either single sequential action trigger mode or bump action trigger mode. In accordance
with the ANSI Standard SNT-101-2002, the trigger is assembled in the single sequential
action trigger mode. To change the trigger mode, see actuating tool instructions in the
Operation section of the manual.
Important: A trigger, which will limit the tool to sequential actuation only, is
available free-of-charge by calling 1-800-321-9443 in the United States and Canada
or 001-731-660-9374 outside the United States and Canada, and providing tool
model number, type, serial number, etc. For identification purposes: the sequential
actuation trigger is red.
aIr fIttInG
The tool is equipped with a 1/4" (6.4 mm) male quick connector coupling. A 3/8" (9.5 mm)
male quick connector coupling is available from PORTER-CABLE and may be used when
a 1/4" (6.4 mm) supply line is not available.

tool partS

a
B
I
H
aSSemBly
7 - ENG
c
e
D