Wiring. Pgs - Craftmade BW116AG3-HW Guia De Instalacion

Ocultar thumbs Ver también para BW116AG3-HW:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4. Installation of Wall Bracket. (cont.)
First determine the approximate position of where
you want the fan to be located on the wall.
[Remember that the fan must be mounted at least 7
feet (2.13m) from the floor.]
NOTE: Ensure there is an electrical source near the
approximate location, such as an existing outlet box
or an electrical outlet, as you will need to pull the
supply wires through the opening in the middle of
the wall bracket.
You MUST use ALL FOUR holes in wall bracket when
installing wall bracket. Position wall bracket on wood
stud or wood post and mark 4 hole locations.
Drill 4 pilot holes over holes marked onto mounting
surface. Position wall bracket over pilot holes and
install screws (provided in hardware pack) into each
hole.
ALTERNATE CONCRETE WALL INSTALLATION: Use all
4 mounting 1/4" (6.5mm) holes when installing wall
bracket on a concrete wall. The 3/16 in. (5mm) concrete
wall anchors necessary for this type of installation are
NOT provided and must be purchased separately. Make
sure that concrete wall anchors can support a total
of 80 lbs.
WARNING: It is very important you use the proper
hardware when installing the wall bracket as this will
support the fan.
5. Wiring.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code (or
the Canadian Electric Code). If you are unfamiliar with
electrical wiring or if the house/building wires are different
colors than those referred to below, please use a qualified
electrician.
WARNING: If using this fan in a DAMP location, this fan
must be connected to a supply circuit that is protected
by a Ground Fault Circuit Interrupter (GFCI) to reduce
the risk of personal injury, electrical shock or death.
Attach wires from 9-wire plug to the supply wires
(from the wall) as follows:
Connect BLACK wire from 9-wire plug to BLACK wire
from wall with wire connector provided. Connect WHITE
wire from 9-wire plug to WHITE wire from wall with wire
connector provied. Connect BLUE wire from 9-wire plug
to BLUE wire from wall with wire connector provided.
1/4"
pilot holes
(6.5mm)
mounting
hole
screws
screws
wire
connector
WHITE
BLUE BLUE
9-wire
plug
BLACK
page 4
stud
stud
wall
bracket
7 feet
(2.13m)
WHITE
BLACK

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Bw116ss3-hw

Tabla de contenido