FeinTech AVS00200 Manual Del Usario página 7

Playback from the analog audio input
Connect an audio source, e.g. MP3 player or TV via the 3.5 mm jack socket . To playback music or sound, set the MODE
switch to the position  (T/F) and turn on the AVS00200. Now start playback on your device and listen to it via the speakers.
The sound is also output via Bluetooth transmitter and audio outputs. Upon successful coupling with a Bluetooth receiver, e.g.
headphone, the PR and TX LEDs  light up continuously.
Playback from the optical audio input
Connect a sound source, e.g. Blu-ray player or TV via the optical audio input  with a Toslink cable. For music playback, set the
MODE switch to the position  and turn on the AVS00200. Now start playback on your device. Sound output is via Bluetooth
transmitter, speakers and audio outputs.
Bluetooth Transmitter Mode
The AVS00200 can transmit the sound via Bluetooth, the playback can be enjoyed with a Bluetooth headphone or Bluetooth
speakers. To do so, connect the audio source (e.g., TV, MP3 player, or PC) to one of the two audio inputs. Set the switch to 
for playback from the analogue audio input  or to  for playback from the digital optical audio input . Then switch the
amplifier on. The PR LED  starts blinking. The Bluetooth device must be paired with the AVS00200. Upon successful coupling
the PR and TX  LEDs light up continuously.
Bluetooth playback on the optical audio output
You can use the AVS00200 to enable an amplifier with optical audio input for play back via Bluetooth. Play with it e.g. music
from your smartphone via your home cinema system. Connect the audio output  to the optical input of the home cinema
amplifier. Then the AVS00200 must be paired with the audio source. Set the MODE switch to the position and switch on. The
pairing lamp PR  starts flashing. Activate the pairing on your Bluetooth device (usually found under „Settings> Bluetooth").
Then confirm the connection of your smartphone or tablet with the found FeinTech_AVS. The two LEDs RX  and PR  then
light up constantly. Start the music playback on your smartphone or tablet.
Note: All other audio outputs are disabled if Bluetooth transmission is active and a paired device is present.
USB port
A connected device (e.g. smartphone) can be charged via the USB port .
Important NOTE
The Bluetooth operating mode as transmitter or receiver is determined at power up. If you turn the MODE switch during opera-
tion, this is only adopted when you switch the AVS00200 on the next time.
Technical data
Power output
Frequency response
Total harmonic distortion THD
Minimum impedance
Signal to Noise Ratio (SNR)
Dynamic range
Chipset
Dimensions
2 x 20 W RMS 4 Ω or
2 x 10 W RMS 8 Ω
20–20.000 Hz
< 0,1 % @ 1W per channel
4 Ω
105 dB, A-weighted
> 100 dB
TDA7491HV
12 x 4 x 16 cm
Input sensivity
Channel separation
Efficieny
Supported data formats
Bluetooth-Version
Bluetooth Codecs
Bluetooth-Frequency
EIRP radiated power
7
680 mV
95 dB
> 90 %
MP3, WMA, WAV
3.0+EDR
SBC, FastStream, aptX
2402–2480 MHz, 70 channels
3.31 dBm / 2.1 mW