EGO CTA9500 Manual Del Operador página 17

CONNECTING THE CULTIVATOR ATTACHMENT TO THE POWER HEAD
WARNING:
running or with the battery installed. Failure to stop the motor and remove the battery
may cause serious personal injury.
This cultivator attachment is designed for use with EGO Power Head PH1400/PH1400-FC.
The cultivator attachment connects to the power head by means of a coupler device.
1. Stop the motor and remove the battery pack.
2. Loosen the wing knob on the power head coupler.
3. If the end cap is on the attachment shaft, remove it and save it in a safe place
for later use. Align the arrow on the cultivator shaft with the arrow on the coupler
(Fig. 5a) and push the cultivator shaft into the coupler until you hear a clear
"CLICK" sound. The coupler should be positioned all the way to the RED LINE
labeled on the shaft: red line mark must be flush with the coupler edge (Fig. 5b).
4. Pull on the shaft of the cultivator attachment to verify that it is securely locked
into the coupler. If not, rotate the cultivator shaft from side to side in the coupler
until a clear "CLICK" sound indicates that it is engaged.
5. Tighten the wing knob securely.
WARNING:
operating the equipment; check it periodically for tightness during use to avoid serious
personal injury.
Never attach or adjust any attachment while the power head is
Be certain the wing knob on the coupler is fully tightened before
CULTIVATOR ATTACHMENT — CTA9500/CTA9500-FC
17