Engine Oil; Engine Oil Recommendations; Adding Engine Oil; Checking Engine Oil Level - Honeywell HW6200 Manual Del Propietário

Engine Oil

Engine Oil
Engine oil is a major factor affecting engine performance
and service life. Non-detergent and 2-stroke engine oils will
damage engine and are not recommended.
• Be sure to use engine oils specified under "Engine Oil
Recommendations."
It is very important to maintain proper level of engine oil to
keep engine in good running condition.
• Check engine oil level prior to each use. Refill engine
oil if oil level is too low.

Engine Oil Recommendations

Use 4-stroke oil, or equivalent high detergent, premium
quality motor oil certified to meet or exceed U.S. automo-
bile manufacturer's requirements for API Performance
Class SL, SJ, or better.
SAE 10W-30 is recommended for general temperature
use. Refer to Figure 17 for information on other viscosities
that may be used. Other viscosities shown in chart may be
used when average temperature in your area is within
indicated range.
FIGURE 17: Recommended Oil Viscosity

Checking Engine Oil Level

To check engine oil level:
Stop generator if engine is running.
1.
Be sure generator is set on flat, level surface.
2.
Remove oil fill cap and wipe off dipstick end with
3.
clean cloth.
Insert oil fill cap to oil fill hole but do not screw in (Fig-
4.
ure 18).
Pull out to read current oil level indicated on dipstick
5.
end.
FIGURE 18: Engine Oil Level
20
www.honeywellgenerators.com
Oil level should be at "H" or somewhere between the
"L" and "H".
FIGURE 19: Engine Oil Level
If oil level is at "L" or below, add recommended oil
(see "Adding Engine Oil"). Do not overfill.
If oil level
is at "H" or somewhere between the "L" and "H",
reinstall oil fill cap and fully tighten.
Reinstall oil fill cap and fully tighten.
6.
Low Oil Protection
When engine oil level approaches an unsafe level, the low
oil protection feature prevents equipment damage by
automatically shutting down engine.
When engine shuts down due to low oil level:
•
The engine start switch will remain in RUN position.
•
You will not be able to start engine until you add
required amount of engine oil.

Adding Engine Oil

NOTE:
i
For initial start-up, follow instructions provided on engine
oil bottle provided with generator.
Stop generator if engine is running.
1.
Be sure generator is set on flat, level surface.
2.
Remove oil fill cap.
3.
FIGURE 20: Oil Fill Cap Removal
Slowly pour oil into oil fill hole.
4.
Check oil level.
5.
Replace oil fill cap and fully tighten.
6.
HW6200 Portable Generator Owner's Manual