Cleaning Spark Arrestor Screen - Honeywell HW6200 Manual Del Propietário

Remove spark plug cap.
3.
FIGURE 32: Spark Plug Cap Removal
Clean any dirt from around spark plug base.
4.
Carefully pull off spark plug cap.
5.
Using a 13/16" spark plug socket wrench, loosen and
6.
remove spark plug.
FIGURE 33: Spark Plug Removal
Inspect spark plug.
7.
If spark plug is damaged or excessively worn, or if
insulator is cracked or chipped use a new spark
plug.
If spark plug is in good condition, reuse existing
spark plug.
If reusing spark plug, clean spark plug with wire
8.
brush.
Measure spark plug gap with wire feeler gauge.
9.
Gap should be: (0.028-0.031 in) (0.70-0.80 mm).
FIGURE 34: Correct Spark Plug Gap
If necessary, adjust gap by carefully bending side
10.
electrode.
HW6200 Portable Generator Owner's Manual

Cleaning Spark Arrestor Screen

Inspect spark plug washer and verify it is in good con-
11.
dition.
Reinstall spark plug by hand to prevent cross-thread-
12.
ing.
After spark plug is seated, tighten with spark plug
13.
wrench to compress washer.
If installing a new spark plug, tighten l/2 turn after
the spark plug seats to compress the washer.
If reinstalling a used spark plug, tighten l/8 - l/4 turn
after the spark plug seats to compress the washer.
Spark plug must be securely tightened. An improperly tight-
ened spark plug can become very hot and could damage
engine. Never use spark plugs that have an improper heat
range. Use only recommended spark plugs or equivalent.
Cleaning Spark Arrestor Screen
Muffler reaches temperatures that can cause serious
burns if touched. NEVER touch hot surfaces.
Generator muffler is equipped with spark arrestor screen,
which must be cleaned according to maintenance sched-
ule (Table 2) to ensure prevention of sparks escaping
generator.
To clean spark arrestor screen, you will need:
Socket wrench with 8 mm socket
Phillips head screwdriver
Wire brush
Stop generator if engine is running. Allow to com-
1.
pletely cool.
Be sure generator is set on flat, level surface.
2.
Using a socket wrench with 8 mm socket, remove
3.
spark arrestor enclosure panel bolts.
FIGURE 35: Remove Spark Arrestor Enclosure Panel
www.honeywellgenerators.com
25