Cardin 1000R Manual Del Usuario página 12

Remarks
These instructions are aimed at professionally qualified "installers of electrical equipment" and must respect the local standards and regulations in
force. The use and installation of these appliances must rigorously respect the indications supplied by the manufacturer and the safety standards and
regulations in force.
Attention! Only for EU customers - WEEE marking. This symbol indicates that once the products life-span has expired it must be disposed of separately
from other rubbish. The user is therefore obliged to either take the product to a suitable differential collection site for electronic and electrical goods or to send
it back to the manufacturer if the intention is to replace it with a new equivalent version of the same product. Suitable differential collection, environmental
friendly treatment and disposal contributes to avoiding negative effects on the ambient and consequently health as well as favouring the recycling of materials.
Illicitly disposing of this product by the owner is punishable by law and will be dealt with according to the laws and standards of the individual member nation.
Description
DKS is an extremely efficient command system via cable, which is easy to install and consists of a numerical keypad, a transponder, a numerical keypad
with transponder functions and an interface, connected by a shielded single wire cable. The keypad consists of a spray painted highly resistant anti-
tamper metal case made in zama and chrome anti wear keys. Easy to install the keyboard features an anti-tamper fastening system that can only be
opened using a special tool. The transponder and the DKSDUALT keypad are housed in a shockproof polycarbonate container with an easy to apply
wall-fastening base. Both products are suitable for surface-mounting external installation and have a protection grade of IP57.
The DKS1000R interface is
factory set to work with the
following appliances
:
Installing the DKS1000R interface (fig. 1)
Depending on the type of installation, work out the position in which the interface will be situated remembering that the site must be indoors (or stored
in a waterproof container if installed outdoors), in a position safe from accidental collision and in a position which the technician can easily reach.
Fasten to the wall at distance of 75 mm between centres using two M4 screws and relative rawlplugs (not supplied) or in a waterproof container using
the supplied double-sided adhesive tape.
DKS250T
DKS250TL
DKSTPT
DKSDUALT
Numerical code keypad via cable
Numerical code keypad via cable with backlighting
Transponder reader
Numerical code keypad with transponder function
12