Start-Up; Removing Iso-Strips; Inserting/Changing Batteries - ADE Fred TE 1700 Instrucciones De Operación

Start-up

Removing iso-strips

The batteries are already inserted on delivery and, for
protection against premature discharge, are provided
with an iso-strip. In order to start up the scales, you must
remove the iso-strips. The battery compartment is located
on the underside of the device.
1. Slide the battery compartment cover to the side in the
direction of the arrow.
2. Pull out the iso-strips.
3. Push the battery compartment cover back into place.

Inserting/changing batteries

For use you require 2 batteries of type CR2032, 3 V.
1. Slide the battery compartment cover to the side in the
direction of the arrow.
2. Slide the batteries against the contact springs under
the large, square retaining tabs and then press them
downwards. The batteries will then snap into place on
the opposite retaining tabs so that the batteries are
firmly set in their holder.
− Pay attention to the correct polarity (+/-).
− The plus pole (+) of each battery must point
upwards.
3. Push the battery compartment cover back into place.
26