Pulsar DIGIFORCE 850S Manual Del Usuario página 5

4
EXTERNAL POWER SUPPLY
The unit can be powered with an external DC power supply (2.1mm
pin) with stabilized voltage ranging from 8.4V to 15V or a 12V vehicle
socket.
Connect the external power supply (AC/DC) or car adapter to the jack
(12) of the cable.
Note: central pin of the power supply that you connect to the "power"
jack of the NV device, must have marking "+".
The power supply may have marking
Connection of an external power supply (
cuts off power supply from batteries.
External power supply DOES NOT charge the batteries in the sight!
Attention! We suggest that you use battery packs EPS3 or EPS5
ensuring from 9 to 30 hours of continuous operation.
5
OPERATION
Remove the lens cap from the objective lens (1). We suggest that you
do not open the lens cap when conducting observation in the daytime
at elevated illumination levels. The light filter, built in the cap, reduces
excessive image brightness and makes observation more
comfortable.
Activate the device by pressing the «ON»
(11) will light up. Battery level
battery is low the color of the indicator will turn red.
To turn off the unit, press the «ON» button (5) again.
Locate an object within 20 to 30 meters.
Adjust image brightness by rotating the adjustment wheel (2).
Brightness icon and brightness level appear in the bottom right
corner of the display. Adjustment range is from 0 to 15.
Rotate the eyepiece (6) and objective lens (1) to achieve a sharp
image.
4
-
+
.
icon ) automatically
(5) button - the green LED
icon appears on the display. If the
1 2
9
10
+ - +
- -
+ + + +
AV out
(yellow)
3 4 5 6
8
7
11
12
5