Hardware Contents; Safety Information - Portfolio 12513LE Manual Del Usuario

HARDWARE CONTENTS

AA
Mounting Bracket
Qty. 1
GG
Thumbscrew
Qty. 2

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install
the product.
WARNING:
●Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by
removing fuse (or switching off circuit breaker).
●Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not
permit wires to contact any surface having a sharp edge. To do so may damage or cut the wire
insulation, which could cause serious injury or death from electric shock.
CAUTION:
●All electrical connections must be in agreement with local codes, ordinances or the National
Electric Code (NEC). Contact your municipal building department to learn about your local codes,
permits and/or inspections.
●Risk of fire — most dwellings built before 1985 have supply wire rated for 140ºF/60ºC. Consult a
qualified electrician before installation.
●Do not connect this fixture to an electrical system that does not provide a means for equipment
grounding. Never use a fixture in a two-wire system that is not grounded. If you are not sure your
lighting system has a grounding means, do not attempt to install this fixture. Contact a qualified,
licensed electrician for information with regards to proper grounding methods as required by the
local electrical code in your area.
●If a dimmer control switch is used with this fixture, obtain professional advice to determine the
correct type and electrical rating required.
(not shown actual size)
BB
Anchor Bolt
Cap Nut
Qty. 3
CC DD
Washer
Qty. 3 Qty. 3
3
EE FF
F
Wire Nut
Wrench
Qty. 3
Qty. 1