Care And Maintenance; Troubleshooting - Portfolio 12513LE Manual Del Usuario

8. With the help of another person, place the assembly over
the mounting bracket (AA) and anchor bolts (BB). Secure
with the cap nuts (CC) and washers (DD). Tighten with a
1/2 in. wrench (not included).
CAUTION: Allow the concrete to dry before installing the
pole assembly.
Hardware Used
CC
Cap nut
DD
Washer

CARE AND MAINTENANCE

To clean, unplug lamp and wipe with a damp, non-abrasive cloth.

TROUBLESHOOTING

PROBLEM
The light will not go on.
Fuse blows or circuit trips
when fixture is turned on.
The fixture shakes in high
winds.
3-YEAR LIMITED WARRANTY
If this product fails due to a defect in materials or workmanship within three (3) years from the date
of purchase, return it along with proof of date of purchase and it will be replaced with the same or
comparable model free of charge.
This warranty is void if damage or defect has resulted from accident, abuse, misuse or faulty repair.
This warranty gives you specific legal rights and you may have other rights that vary from state to
state.
IN NO EVENT WILL LIABILITY EXTEND TO ANY CONSEQUENTIAL, SPECIAL, INCIDENTAL
OR INDIRECT DAMAGES OF ANY KIND ARISING OUT OF THE USE OR MISUSE OF THIS
PRODUCT. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF
INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE EXCLUSION OR LIMITATION
MAY NOT APPLY TO YOU.
POSSIBLE CAUSE
1. No power.
2. Fixture may be wired
incorrectly.
3. Switch may be wired
incorrectly.
Crossed wires or power wire is
grounding out.
1. The mounting bracket (AA)
may be
assembledincorrectly.
2. The screws and cap nuts
may be secured incorrectly.
x 3
x 3
CORRECTIVE ACTION
1. Make sure lamp fixture is
plugged in and power is on.
2. Check wiring.
3. Check wiring.
Consult a certified electrician.
1. Make sure the mounting
bracket (AA) was installed at
ground level.
2. Make sure the screws and cap
nuts were secured tightly.
6