GYS GYSPOT ARCPULL 200 Manual Del Usuario página 24

It is recommended to make some preliminary welding tests if other consumables are used.
Thickness of the support sheet metal (value
To increase or decrease the sheet metal thickness to which the insert will be welded use keys D+ and D-.
If the thickness of the sheet metal is less than that shown on the display, a marking on the rear of the weld may appear.
When the station displays «
an optimal weld.
If this pictogram does not appear, then the maximum sheet metal thickness has been reached. Beyond this thickness,
the welding of the insert is no longer guaranteed.
Power coefficient (value
The Power coefficient is used to adjust the ignition current, the arc energy (current, time) and the attachment current.
Power can be adjusted between -10 and +10. To increase or decrease this coefficient press keys G+ and G-.
Note: Weld synergies are optimized with a default Power coefficient value of 0.
Power Action on the product
• Increase the ignition current
• 2% increase in arc current up to 200A, then
+1 point
3% increase in arc time up to 500ms.
• Increase the attachment current.
• Decrease the ignition current
-1point • 2% reduction of the arc current.
• Decrease of the attachment current."
To change the other synergistic welding parameters (materials, type and size of insert, gas) refer to the chapter «Syner-
gistic Settings».
WELDING IN MANUAL MODE
In Manual Mode, times,currents, coefficients for the different welding phases and the lifting height of the insert need
to be set by the user.
Ri ng
Fe
+1
To increase or decrease the arc duration (value
To increase or decrease the arc current (value
To change the other synergistic welding parameters (materials, type and size of insert, gas) refer to the chapter «Manual
O VERVO LTAG E DEFECT
Settings».
CO M .
24
GYSPOT ARCPULL 200
Type, material and size of
insert
Coefficient Power
», the sheet thickness is high enough so that it is not marked on the back while having
)
1. 5m m
G as
Arc duration 2. 0
zone de
message
message area
t
m s
100
zone de
message
DEFECT
Gouj on M 5
Fe Ar CO_8%
+1 3. 0
zone de
message
)
Influence on the weld
• Better arc ignition on poorly degreased sheet
metal..
• Better ignition in cold weather (<5°C).
• 2% increase of arc energy.
• Reduced risk of sticking during ignition.
• Suitable ignition in hot weather (>35°C).
• 2% decrease of arc energy.
t I
m s A
100 200
message
area
t I
m s ), use the keys G+ and G-. A
100 100
I
A
), use the keys D+ and D-.
100
zone de
O VERHEATI NG DEFECT
message
PRESSED KEY
Gas to use
Sheet metal thickness
M ai n M enu
> Set t i ngs
M anual M ode
Conf i gur at i on
Arc current
Conf i gur at i on
> Pr egas > 100m s
Pos t gas 500m s
Language EN
Pr oduc t r es et
I nf o
M anual Set t i ngs
St ar t - up > Q = 0
Sy ner gi c Set t i ngs
EN