Use; Cleaning; Troubleshooting - FAR MADO Manual De Instrucciones

ENGLISH

USE

Make sure that the appliance is unplugged and switched off (The red control lamp
1.
lights are off.).
Take the lid off the deep fryer.
2.
Remove the frying basket and fill the container with oil or grease (maximum
3.
3.0 L). The filling level must be located between the minimum and the maximum
level.
Insert the plug into a 230V, 50 Hz power socket. The red control lamp lights up.
4.
Set the desired temperature by turning Thermostat knob (3).
The green control lamp lights up. Once the set temperature has been reached the
5.
green control lamp goes off. Place the frying basket containing the items to be fried
carefully into the hot fat.
The green control lamp switches on and off several times during frying. This is
6.
normal and it indicates that the temperature is controlled by the thermostat and is
being maintained. Once the frying time is over (the frying times are to be found on
the packaging of the food or in the recipe), please take out the frying basket.
Let the oil drip from the food being fried.
7.
In order to switch off the machine, please turn the temperature regulator to OFF
8.
and remove the plug from the socket. Wind the mains lead up in the form of a
spiral in the cable compartment.
WARNING:
Always pull out the plug from the mains socket before cleaning and wait until
the unit has cooled down.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
• Under no circumstances should the device be immersed in water for

cleaning.

GB-10
CLEANING
• In order to change the oil, pull out the deep frying fat container and pour the oil
out at the side.
• Clean the deep frying fat container, the lid and the housing with a damp cloth and
household detergent if necessary. Please do not immerse in water.
• The deep frying basket can be cleaned in the usual way in soapy water.
Housing
Clean the housing after use with a slightly damp cloth.
TROUBLE SHOOTING
Device is not working

Troubleshooting:

• Check the mains connection.
• Check the position of the thermostat.
Other possible causes:
• The device is fitted with a safety switch (9).
• This prevents the heater being switched on accidentally.
• Check that the control element is correctly in place.
Overheating Protection
• If you should accidentally switch on your deep fat fryer when there is no oil or fat
in it the overheating protection is automatically turned on. The appliance is no
longer ready to be used. Unplug the deep fryer.
• Only after the device has been left to cool down completely should the
"RESTART" button (8) on the rear of the control element be operated in order to
use the deep fat fryer again. For this you should use a plastic or wooden object that
is the least 4 cm long.
ENGLISH
GB-11