Additional Information - USRobotics MAXg Guía Breve De Instalación

Ocultar thumbs Ver también para MAXg:

Tabla de contenido

Idiomas disponibles

English

To restore the factory default settings, use a small object such as a paper

clip to press in and hold the reset button on the back of the access point

for 10 seconds.

After you restore the access point, reconfigure the access point by per-

forming "Step Two: Configure the Basic Settings" on page 5.

My wireless device does not establish a wireless connection to the

access point after I changed the settings

In the configuration utility for your wireless device:

1. Ensure that you are connecting to the Wireless MAXg Access Point by veri-

fying the WLAN MAC address.

2. Ensure that the same encryption options, and their passphrase or key, are

used on both the wireless device and the access point. If you change the set-

ting on the access point, you must also change the settings of every wireless

device that is intended to connect to the access point.

I cannot access the configuration pages

1. In your Web browser, make sure that you are entering the correct IP address

for the access point. If you are using a Windows operating system, you can

find the IP address by running the Network Device Locator. To run the util-

ity:

Windows Vista or XP: click Windows Start > All Programs > USRobotics

Network Device Locator and click Next.

Windows 2000: click Windows Start > Programs > USRobotics Network

Device Locator and click Next.

2. If you are trying to access the configuration pages wirelessly, try to access

them with a wired connection as follows:

A. Using a computer connected by Ethernet cable to the same networking

device as the access point, start a Web browser.

B. Enter the IP address of the access point and press enter.

If you can access the configuration pages with a wired connection, you

are experiencing a wireless connectivity issue. See step 5 under "General"

on page 10.