Titan Controls Apollo 5 Guía Sencilla

®
Apollo 5
240 Volt In-Line Timer
Easy Guide
VANCOUVER, W ASHINGTON U.S.A.
Instructions for Use
1. Place Apollo 5 near equipment to be operated, but
away from water, mist, spray, etc.
2. Plug Apollo 5 into the ballast to be controlled. Im-
portant: If your ballast has 2 power inlet recepticles,
make sure to plug the Apollo 5 into the 240 volt
recepticle. If you want to use 120 volt power, you
must use an Apollo 4.
3. DO NOT exceed 10 amps.
4. Set the 24 hour timer to the correct hour and
approximate minute.
5. Push the captive trippers to the OUTER RING for
the entire period the ballast is to be 'ON'.
6. Push the captive trippers to the INNER RING for
the entire period the ballast is to be 'OFF'.
7. Verify that the input power is maximum 240 volts.
Exceeding this voltage will destroy your ballast and
void your warranty.
8. Plug the Apollo 5 into a 240 volt outlet.
9. Ballast will cycle "On" &"Off" at desired settings until
power is defeated.
®
www.titancontrols.net
For technical assistance call us at
1-888-80-Titan or 1-888-808-4826.
Controller Specifi cations
Size: 5"H x 4"W x 2"D
Weight: 1 lb.
Voltage Input: 240 volts
Voltage Output: 240 volts
Maximum Amperage: 10 amps
Hertz: 60 Hz
Switch Rating: 1350 Watt Tungsten
o o
Operating Temperature: 40 to 125
o o
Storage Temperature: 32 to 135 F | 0
Cord Set: 16/3 AWG SJTW
Controlling a Ballast using
an In-Line Timer
Apollo 5
240 Volt
to 240 Volt Ballast
Power Input
o o
F | 5 to 53 C
o o
to 57 C