Titan Controls Apollo 1 Guia Facil

http://waterheatertimer.org/Woods-timers-and-manuals.html#cycle
Apollo 1
Recycle Timer with Photoswitch
Easy Guide
VANCOUVER, W ASHINGTON U.S.A.
Instructions for Use
1. Mount Apollo 1 near item to be controlled but away
from water, mist, etc.
2. Plug equipment to be activated into back of piggy
back cord set.
3. Plug male end of piggy back cord set
into 120 volt, 15 amp outlet.
4. Set preferred timing on controller face
to proper settings.
5. Turn on power for device to be controlled.
6. Turn on Apollo 1 power switch.
7. Unit will now activate and deactivate
equipment based on preferred settings.
8. To reset Apollo 1, turn off power switch and
then turn back on.
Controller Specifi cations
Size: 8" 4" 2.5"
H x W x H
Weight: 2 lbs.
Voltage Input: 120 volts
Voltage Output:120 volts
Maximum Amperage: 15 amps
Hertz: 60 Hz
Accuracy: +/- 5%
Cord Set: 6 feet, 14 AWG
ON Time: 3 seconds to 30 minutes
OFF Time: 3 seconds to 8 hours
o o
Storage Temperature: 0 to 135 F
o o
Operating Temperature: 35 to 125 F
www.titancontrols.net
For technical assistance call us at
1-888-80-Titan or 1-888-808-4826.
2
Controlling a CO Generator
Apollo 1
CO 2
Generator
Controlling a CO 2 Tank with Generator
Apollo 1
Controlling a Water Pump
Apollo 1
Tank with Pump
Controlling a Fan
Apollo 1
Fan