Homak HS40135505 Guía De Utilización Y Directivas De Funcionamiento página 4

FOR HS40135505:
1. Remove small screws and washers from back of barrel rest.
2. Bolt barrel rest to back panel of cabinet using the two smaller
holes located on the back panel (Part E).
FOR HS40135508:
1. Decide preferred height of barrel rests. Use masking tape to
mark your location if necessary.
2. Barrel rest can be cut to provide different heights.
3. Remove paper backing, and adhere to the gun cabinet.
4. Do not reposition, adhesive may lose its stickyness.
1. Drill hole in concrete wall that has a slightly larger diameter than the
mounting sleeve and bolt.
2. Insert mounting sleeve and bolt into wall.
3. Install fl at washer onto bolts
4. Line up cabinet onto the mounting bolts.
5. Place lock washer onto bolt, and then the nut.
6. During the tigtening process, the bolt will expand the mounting sleeve
inside the concerete and create a fi rm grip.
1. Open the safe door.
2. Press the red programming button.
3. Enter code, be careful not to make any mistakes.
4. Press * or # key to set the code.
5. BEFORE SHUTTING SAFE DOOR, test the code.
OPENING YOUR SAFE USING THE ACCESS CODE
1. Insert access code followed by the "#" button.
2. Turn handle to the left to open the door.
1. Close safe door.
2. Rotate the handle to the locked position.
BARREL REST INSTALLATION
MOUNTING INSTRUCTIONS
PROGRAMMING YOUR SAFE
HOW TO LOCK THE SAFE:
- 3 -