Eiko SCSS-1C-50K-U Instrucciones De Instalación

SAFETY PRECAUTION:
Warning: Risk of fire and electrical shock! Before beginning installation or service, disconnect the power by turning off
the circuit breaker. Turning the power off by using the light switch is not sufficient to prevent electrical shock. This light
is for outdoor use and should not be used in areas of limited ventilation or high ambient temperature. All work should be
performed by a qualified electrician. This product must be installed in accordance with the applicable installation code by
a person familiar with the construction and operation of the product and the hazards involved.
INSTALLATION:
1. Remove the junction box mounting plate from the top of the fixture by loosening
one side screw and sliding the fixture plate out from the holding brackets on the top
of the casting.
2. Install the mounting plate to the junction box with two screws (not provided). The
bracket should be positioned to allow the fixture to be "square" with the sides of the
canopy the fixture is mounted to.
3. Hang the fixture from support spring while wiring the unit. Bring the fixture input
wires from the top of the fixture and connect to the power leads in the junction box –
black to black (hot), white to white (neutral), and green to green (ground).
4. Connect the main housing to the junction box bracket. Hold in place while
reinstalling one side locking screw.
5. Turn on the power. The fixture will come to full output in several seconds.
• Note: Do not remove the bottom lens or touch the LED optics. All LEDs are
preinstalled and ready to operate.
TROUBLESHOOTING CHECKLIST: If the light does not work:
-- Check your power source.
EiKO Global, LLC • 23220 W. 84th St, Shawnee, KS 66227 • (P) 1-800-852-2217 • (F) 1-800-492-8975 • eiko.com
EiKO Canada • 81 King St, Barrie, Ontario L4N 6B5 • (P) 1-705-721-5189 • (F) 1-705-721-7855 • orderdesk@eiko.com
INSTALLATION INSTRUCTIONS
SCSS-1C-50K-U & SCSS-2C-50K-U
LED Surface Canopy Square, Small
-- Check electrical connections.