Important; Emptying The Dust Drum; Insert Hose - RIDGID 1000RV0 El Manual Del Propietario

SP6962 Pro Pack Plus ESF.qxp_SP6962 6/24/15 1:21 PM Page 10
Operation
WARNING: Do not operate
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
3. When the liquid in the drum reaches a
predetermined level, the float mech-
anism will rise automatically to cut off
suction. You will know that the float has
risen because Vac airflow ceases and
the motor noise will become higher in
pitch, due to increased motor speed.
When this happens, turn off the Vac,
unplug the power cord, and empty the
drum.
4. After using the Vac to pick up liquids,
the filter must be dried to avoid
possible mildew and damage to the
filter.
IMPORTANT: To avoid damage to the
Vac, do not run motor with float in raised
position.

Emptying the Dust Drum

WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before emptying
the drum.
1. The Vac comes equipped with a drain
for easy emptying of liquids. Simply
unscrew the drain cap and tilt forward
slightly to empty the drum.
Drum
Drain Cap
(continued)
2. Another option is to remove the power
head to empty contents of the dust
drum, simply lift the two drum latches
on the front and rear of the Vac and lift
the power head up and off the dust
drum and set to the side.
3. Set the power head upright in a clean,
dry area while emptying the drum.
4. Dump the drum contents into the proper
waste disposal container.
Power
Head
Drum
Latches (2)
Drum

Insert Hose

Insert the push button end of the
Superflex Hose into the Vac inlet, located
on the side of the Vac. The hose should
snap into place.
To remove the hose from the Vac, press
the release button in the hose assembly
and pull the hose out of the Vac inlet,
as shown.
10
Vac Inlet
Superflex Hose
Locking End