Publicidad
Enlaces rápidos
M92E
Biradial (elliptical),
.4 x .7 mil
N78S
78 rpm, spherical,
2.5 mil
{Output voltages given for stereo cut record; for MONO cut record, output voltage at both left chan-
nel and right channel cartridge terminals will be 71% of figure above.
*Do not exceed maximum indicated tracking force.
Optimum Load: 47,000 ohms resistance in parallel with 200 to 300 picofarads capacitance per
channel. Load resistance can be up to 70,000 ohms with almost no audible change in frequency re-
sponse. Total capacitance includes both tone arm wiring and amplifier input circuit.
Certification: Conforms to European Union directives, eligible to bear CE marking; meets
European Union EMC Immunity Requirements: EN 50 082-1, 1992.
Net Weight: 7.3 grams including standard 1/2 in. mounting adapter. Without adapter, cartridge is
compatible with pre-set P-Mount arm.
THIS CARTRIDGE FEATURES THE SHURE BIRADIAL NUDE DIAMOND TIP
E 2002, Shure Incorporated
27A2172 (BD)
SPECIFICATIONS
Red
5.0 mV
Green
4.0 mV
Its contact area is longer and narrower than the traditional spherical tip-
groove contact area. This results in dramatic reduction of both harmonic dis-
tortion and intermodulation distortion.
To clean the stylus, use the brush supplied with the cartridge with alcohol or
an alcohol-distilled water solution
Brush only from back to front as shown. Commercial cleaning solutions may
cause stylus damage.
MODEL M92E User Guide
Within
20 to
18,000 Hz
2 dB
20 to
Mono
17,000 Hz
0.75 to 1.5
20 dB
grams
at 1 kHz
(1.25 grams
optimum)
Mono
1.5 to
3 grams
Printed in U.S.A.
Publicidad
Manuales relacionados para Shure M92E
Resumen de contenidos para Shure M92E
- Página 1 Net Weight: 7.3 grams including standard 1/2 in. mounting adapter. Without adapter, cartridge is compatible with pre-set P-Mount arm. THIS CARTRIDGE FEATURES THE SHURE BIRADIAL NUDE DIAMOND TIP Its contact area is longer and narrower than the traditional spherical tip- groove contact area.
- Página 2 MOUNTING white rouge blanc blanco weiss rojo RG LG green blue vert bleu grün blau verde azul TRACKING FORCE IN A P-MOUNT ARM After installing the cartridge, it is not usually necessary to adjust the tracking force in a pre-set arm. SKATING COMPENSATION (where applicable) Set the skating compensation mechanism according to the tone arm manufacturer’s instructions.
- Página 3 You should retain proof of date of pur- chase. Shure is not liable for any consequential damages. If this Shure product has any defects as described above, carefully repack the unit, have it insured, and return it prepaid to:...
- Página 4 60202–3696, garantiza al dueno de este producto que este mismo este libre de cualquier defecto, duran- te uso normal, en materiales y labor por un período de un año desde su adquisición. Shure no es responsable por danos que resulten por otras consecuencias. Si este producto es defectuoso en alguna manera, empá- quelo cuidadosamente y devuélvalo a: Shure Incorporated, Attention: Service Department, 222 Hartrey Ave-...