Bissell Big Green Complete 7700 Serie Guia Del Usuario página 12

O
perations
When you are finished
1. turn off the heater, wet clean, and
power buttons.
2. Remove the collection tank from the unit by
opening the quick release hose holder and
lifting the tank straight up by the handle.
3. Remove the top lid from the collection tank
and set it aside.
4. empty dirty water into a sink, toilet or outside.
Pour the dirty water out from the corner of the
tank. Rinse out the tank thoroughly.
5. allow all parts to dry before storing.
Hard floor cleaning
1. see "getting Ready to Wet clean" on
Page 10.
2. be sure to use bissell 2X hard floor
solutions in the solution tank for hard
floor cleaning. fill the formula tank by
first unscrewing the measuring cap.
always use genuine bissell formulas to
maximize cleaning and for the safety of
your machine. fill tank to fill line with hot
tap water. add one full cap of formula.
screw measuring cap tightly back onto
the solution tank.
3. set the solution tank back in the machine.
4. attach microfiber pad to quick dry hard
floor tool by attaching to the Velcro strips
on the top of the tool.
5. attach the hard floor tool to end of the wand.
6. Place tool directly on the hard floor surface,
resting on the pad.
7. squeeze the spray trigger to moisten
the pad with cleaning solution.
Caution: Do not oversaturate.
8. move the tool back and forth across
the floor to clean. squeeze spray trigger
as needed.
9. tilt the tool forward and pull back. this will
create the best suction and will help get the
hard floor surface as dry as possible.
10. continue until room is complete.
11. see "When you are finished"
instructions above.
12. be sure to remove the microfiber pad
and clean it by hand or machine wash
as needed. allow it to dry completely
before next use.
12
2
4
CAUTION:
your big green complete® is
designed to clean hard flooring
such as ceramic tile, vinyl, lami-
nate, marble, stone. and sealed
hard wood floors. do not use on
any unsealed hard floor surfaces.
4
3